beautypg.com

AT&T 1305 User Manual

Page 12

background image

I N C A S E O F D I F F I C U L T Y

If the system does not respond to remote commands:

• Make sure you are calling from a touch tone telephone. If you hear clicks

when you dial, the phone is not a touch tone phone.

• There might be noise or interference on the phone line. Press dial buttons

firmly.

• Make sure you are entering the correct Remote Access Code.

If you forget your Remote Access Code:

1 Unplug the answering system.
2 Hold down

P and plug the system back in. You’ll hear three short

beeps, followed by a long beep.

3 Release

P. The Remote Access Code has been reset to 1234 (the Priority

Calling Code is 1235).

4 To change the Remote Access Code, see “Changing Your Remote Access

Code” in the REMOTE OPERATION section of this manual.

If you’re having a problem not described above:

1 Unplug the power cord.
2 Remove the microcassette, turn it over, and reinstall it.

3 Wait about one minute, then plug the power cord into the electrical outlet.

The system will rewind the tape.

4 When the tape stops (after about one minute), record an announcement.

11