AT&T 1305 - Manual (Page 10)

Room Monitor
You can call the answering system and listen to any activity in the room for
15 seconds.
1 Connect with the answering system and listen to messages.
2 Press
3 3. You can listen after the beep.
3 After 15 seconds, the system exits Room Monitor and beeps twice.
Turn System Off
1 Connect with the answering system and listen to messages.
2 Press
6 6, then hang up.
Turn System On
When the system is off, it answers after 10 rings and sounds a three-second tone.
1 Enter your four-digit Remote Access Code. You’ll hear a long tone
indicating the system is on and ready for a remote command.
2 The system plays any messages, then remains on unless you turn it off.
When the Tape is Full
When the recording side of the tape is full, the system answers after 10 rings
and beeps.
1 Enter your Remote Access Code within eight seconds after the beeps to
listen to messages.
2 Press
0 0 after you listen to messages to clear them and make room for
new messages.
R E M O T E O P E R A T I O N
9