Connections – Samsung HT-D5500-ZA User Manual

Page 22

English

Connections

CAUTION

Do not insert any other card except the TX card dedicated to the product.
If you insert a different TX card, you can damage the product and may not be able to remove the
card easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may
cause a problem.
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
If no sound is heard from the wireless surround speakers, switch the mode to Dolby Pro
Logic

II.

In 2-CH mode, you will hear no sound from the wireless surround speakers.

NOTE

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is
too close to the product, sound from the speakers may be disrupted because of interference.

If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses
the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted

because of interference.

The maximum transmission distance from the product to the wireless receiver module is about 33
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or
metallic wall is between the product and the wireless receiver module, the system may not operate
at all, because the radio wave cannot penetrate metal.

If the product doesn’t make a wireless connection, you need to run an ID Set between the
product and wireless receiver module. With the product turned off, press “0”

”1””3””5” on

the remote control. Turn on the wireless receiver module. Then, press and hold the “ID SET”
button on the back of the wireless receiver module for 5 seconds, and then turn the product on.

Connecting the FM Antenna

Connect the FM antenna supplied to the FM
ANTENNA Jack.

Slowly move the antenna wire around until you
ﬁ nd a location where reception is good, then
fasten it to a wall or other rigid surface.

NOTE

This product does not receive AM broadcasts.



✎








✎



FM ANT

WIRELES

FM Antenna (supplied)

HT-D5500_XAA_1226.indd 22

2011-12-26 2:19:42