Samsung RS25H5000WW-AA - Manual (Page 26)

English - 26
3. Insert a new water filter into the filter housing.
LOCK
UN LO CK
LO CK
LOCK
UN LO CK
LO CK
LOCK
UN
LOC
K
LO CK
LOCK
UN LO CK
LO CK
LOCK
4. Turn the new water filter 90˚ clockwise.
LOCK
UN LO CK
LO CK
LOCK
UN LO CK
LO CK
LOCK
UN LOC
K
LO CK
LOCK
UN LO CK
LO CK
LOCK
5. Press and hold the Water button for 3 seconds
after changing the filter to reset the filter
indicator.
Confirm the indicator turns blue. When you
replace the water filter, some water may leak
from the water filter housing.
Make sure to wipe up any leakage that may
have occurred.
Removing residual matter from inside the
water supply line after installing a new
filter
LOCK
Water Ice
1. Turn ON the main water supply.
2. Press the Water button on the control panel.
Place a cup or glass under the water outlet,
and then push the cup or glass against the
dispenser pad until you hear a “click”.
3. Flush 3 gallons of water through the filter.
(Flush approximately 6 minutes.)
This will clean the water supply system and
remove air from the lines.
4. Additional flushing may be required in some
households.
5. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser.
This is the result of air getting into the line.
It poses no problem to the operation of the
refrigerator.
DA68-02981E-01.indb 26 14. 1. 20. �� 7:48