Samsung YP55V-XAX - Manual (Page 8)

15 14
Connecting yepp to PC with USB cable
MODE
REC / ENC
VOL
When USB driver is not Installed automatically,
refer to next page. 7
Upon installation of the USB driver
"SAMSUNG YP-55”
will appear in the
[System Properties] ➝ [Device Manager].
6
N N o o t t e e : :
How to check USB driver How to check USB driver
Windows 98:
Control Panel
➝ System ➝ Device Manager ➝
Universal Serial Bus controllers/Samsung YP-55 Class
Windows 2000:
Control Panel
➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device
Windows XP:
Control Panel
➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device
USB connect cable
Plug one end of the USB cable into the USB
port on the back of the PC. 3
Connect the opposite end of the USB cable to the
USB cable port on the bottom of the yepp.
● If you disconnect the USB cable from your PC while
implementing a command or initializing during USB driver
installation, your PC may not function correctly.
● The yepp will automatically turn on.
4
USB driver is installed with a message saying that it
is searching for a new device. You may not see the
display screen during installation.
Go to the device manager to check that installation
has been successfully completed. 5
N N o o t t e e : :
For WinXP, the following window will appear whenever
you connect the USB cable to your yepp.
55-eng-new-australia 8/29/03 10:36 AM Page 14