Samsung HLR5677WX-XAA - Manual (Page 12)

4
Press the … or † button to select the
Antenna connection, then press the
ENTER button.
●
Air : “Air” antenna signal
Cable : “Cable” antenna signal
Air+Cable : “Air” and “Cable” antenna
signals
●
If the CableCARD is inserted into the
“CableCARD” slot on the rear panel,
“Cable” and “Air+Cable” are not
available.
When selecting Cable TV system:
Press the ENTER button to start the auto
program. By default, the cable TV system
is set to “STD”.
If you want to select another type of
cable system, press the œ button and use
the … or † button to select one of Analog
or Digital “STD”, “HRC” and “IRC”.
Press the ENTER button.
●
STD, HRC and IRC identify various
types of cable TV systems.
Contact your local cable company to
identify the type of cable system that
exists in your particular area.
At this point the signal source has been
selected.
5
Press the √ button to select “Start”, then
press the ENTER button to start the auto
program. The TV begins memorizing all
available stations. Press the ENTER
button at any time to interrupt the
memorization process.
Press the EXIT button to exit.
●
The TV must be connected to an
antenna in order to receive digital TV
signals. Even if a particular channel is
deleted from the memory, you can
always tune to that channel directly
by using the number buttons on the
remote control.
Auto Program
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Select the antennas to memorize.
Air
Cable
Air+Cable
Start
Start
Start
Auto Program
Enter Return
Auto Program in progress
Cable Channel 26
Stop
Auto Program
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Start
Select the cable system.
Analog
Digital
STD ✔
HRC
IRC
STD ✔
HRC
IRC
English-12
Auto Program
Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Select the cable system.
Analog
Digital
STD
HRC ✔
IRC
STD ✔
HRC
IRC
Start
Move
BP68-00461A-00Eng_1206 12/6/04 12:39 PM Page 12