AT&T 929 User Manual
Page 6
4
Set the tone/pulse switch. If you have touch tone service, set
the switch to TT (tone). If you have dial pulse (rotary) service,
set the switch to DP (pulse).
Connect the handset to the telephone. Plug the handset coiled
cord into the handset jack on the left side of the telephone
base. Plug the other end of the handset coiled cord into the
handset, then hang up.
Connect the telephone line cord to the telephone. Plug the
telephone line cord into the jack labeled
LINE IN on the
telephone base as shown below. If you subscribe to high-
speed internet service (Digital Subscriber Line - DSL) through
your telephone line, you must have a DSL filter between
the telephone base and the telephone wall jack. The filter
will prevent noise and caller ID problems caused by DSL
interference. Please contact your DSL service provider for more
information about DSL filters.
Check for a dial tone. Lift the handset or press to listen for a
dial tone. If you cannot hear a dial tone, slide
HS VOL (handset
volume) or
SPK VOL (speakerphone volume) upward. If you still
do not hear a dial tone, see the
Troubleshooting section on
page 14 of this user's manual.
3.
4.
5.
6.
Installation
Telephone wall jack
DSL filter (not included)
required if you have DSL
high-speed internet service.
Tone/pulse switch
Telephone line cord