Samsung LTN325WX-XAA - Manual (Page 31)

English-
23
O P E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH
and CH
buttons to scan through the channels. This eliminates the need to change channels by
entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button to
display the menu.
Press the UP/DOWN
buttons to select “Channel”,
then press the ENTER
button.
2
Press the UP/DOWN
buttons to select “Air/CATV”,
then press the ENTER
button.
Repeatedly press the
UP/DOWN
buttons to
cycle through these choices:
Air (antenna), STD, HRC or IRC
(all cable TV).
Press the UP/DOWN
buttons to select the Video
signal source, then press the
ENTER
button.
Note : STD, HRC and IRC identify various types of cable
TV systems. Contact your local cable company to identify the
type of cable system that exists in your particular area.
At this point the signal source has been selected.
Proceed to “Storing Channels in Memory” (next page).
venus-04-en 6/28/03 8:16 AM Page 23