Samsung RS265LABP-XAA - Manual (Page 27)

27
INST
ALLA
TION INSTR
UCTIONS
INSTALLATION OF THE WATER DISPENSER LINE
COVER FILTER
(A)
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
1) As shown, the fixed cap separates from the refrigerator by rotating
it counterclockwise.
Remove the water filter from the box and put a month indicator
stick on the filter as shown.
2) If the water filter was installed in March, put on the "SEP" sticker.
3) Remove the protective cap then position and insert the
filter as shown.
4) Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in
position. Do not overtighten.
Please check that the indication line aligns with the lock position.
Install the water filter.
NOTE
Connect the water line to the refrigerator.
Keep the cap(A) in a safe place for recapping, when you
don’t use the filter.
NOTE
Water line must be connected to drinkable water only.
Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnect.
Do not overtighten the compression nut.
NOTE
NOTE
Compression Nut (1/4
(Provided)
Compression Fitting
(Provided)
Compression Nut (1/4
(Purchased)
Plastic Tubing
(Purchased)
Copper Tubing
(Purchased)
Ferrule
(Purchased)
Household Water Line
Refrigerator 1) Slip the compression nut through the provided
plastic tubing.
2) Tighten the compression nut onto 1/4”
comprression fitting.
3) Tighten the compression nut onto the com-
pression fitting.
4) Turn water on and check for any leakage.
Using Copper Tubing
- Slip the compression nut and ferrule on
copper tubing as shown.
Using Plastic Tubing
- Insert the molded end of the plastic tubing
into the compression fitting.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)