Samsung RS265LABP-XAA - Manual (Page 26)

26
CHECKING THE WATER DISPENSER LINE
1) In order to operate the ice maker properly, water pressure of 20 ~125 psi is required.
In this range a 170 cc (5.74 ounces) paper cup can be filled in 10 secs.
2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.
3) If the refrigerator is installed in an area with low water pressure (below 20psi), you should install a
booster pump to compensate.
4) Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis-
penser lever until the water runs from the outlet.
NOTE
Water line installation kit is available at extra cost from your dealer. The refrigerator
manufacturer recommends using a water supply kit containing copper tubing.
Connecting to water supply line
- Shut off the main water supply line and turn
the Ice maker to the off position.
- Locate the nearest cold drinking water line.
- Follow the instructions in the ice maker
installation kit.
- After connecting the water supply with water
filter, turn on water supply and flush 4 or
more gallons into a bucket to clear the water
filter
1. Cold Water line
2. Pipe Clamp.
3. Water Line Installation Kit
4. Shut Off Valve