Samsung RS25H5000SR-AA User Manual

Page 17

English - 17

SETTING

2. Tighten the compression nut (

B ) into the

compression fitting. Do not over-tighten the
compression nut (

B ).

3. Turn water on and check for any leakage.

Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the
water line, cut off 1/4” of the plastic tubing
to make sure you get a snug, leak-free
connection.

When using power cord.

To prevent power cord damage, arrange the
remaining power cord on top of refrigeration rear
and fix.

Non operation

Removing residual matter inside the water
supply line after installing filter

LOCK

Water

Ice

LOCK

1. Turn ON the main water supply.
2. Press the Water button and push the dispenser

pad.

3. Flush 3 gallons of water through the filter before

use. (Flush approximately 6 minutes.)
This will clean the water supply system and
remove air from the lines.

4. Additional flushing may be required in some

households.

5. Open the refrigerator door and make sure there

are no water leaks coming from the water filter.

A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser.
This is due to air getting into the line.
It should pose no problem to operation.

SSEDA-14 (RS25H5121) ��.indd 17

2013. 11. 28. �� 11:28