Samsung HTDM150TH-XAX - Manual (Page 24)

2 1
4 3
Setting the Speaker Mode Setting the Test Tone
Press MENU button.
Press Cursor
button to move to
‘Audio’ and then
press ENTER button.
In the Speaker
Setup, press the
ENTER button again.
L: Front Speaker (L) C: Center Speaker SW: Subwoofer
R: Front Speaker (R) LS: Rear Speaker (L) RS: Rear Speaker (R)
Press Cursor , ,
, buttons to move
to the desired
speaker and then
press ENTER button.
• For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL
➝ NONE.
• For L and R, the mode is set to SMALL.
• With (Dolby Pro Logic II), the delay time may be different for each
mode.
• With AC-3 and DTS, the delay time is set between 00 and 15mSEC.
• Depending on PRO LOGIC and STEREO, the speaker mode may vary.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
45 46
Note
SETUP
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
2 1
Press MENU button.
Press Cursor
button to move to
‘Audio’ and then
press ENTER button.
3
Press Cursor button
to move to ‘TEST
TONE’ and then press
ENTER button.
• The test tone will be sent to L ➝ C ➝
R ➝ RS ➝ LS ➝ SW in that order.
If the button is pressed again at this
time, the test tone will stop.
To end the test tone,
press TEST TONE button.
Press TEST TONE button.
• Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
• Use this function to check that each speaker is
correctly connected and that there is no problem.
When manually testing using the TEST TONE button
Multi-Channel Pro Logic Mode
Start