Samsung RFG295AAWP-XAA - Manual (Page 24)

24_ Operating
Check the
water level
Test button
Vegetable &
Fruit Drawers
Ice-Maker
Deli Drawer
Operating your SAMSUNG French Door
Refrigerator
usinG tHE CoLD watER DisPEnsER
using the ice Dispenser
Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass.
Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.
Press the ice / water button to select the type of you want
No ICE
Select this if you
want to turn ice
maker off.
PUSH
Caution
• When Cubed Ice is selected after using the Crushed Ice feature, a small amount of
residual crushed ice might be produced.
• Water Dispenser Installation
After installation, press the dispenser arm for at least 2 minutes to remove trapped air
from the water line and to fill the water system.
Caution
Please wait 2 seconds before removing the glass under the dispenser to prevent spills.
If the Refrigerator door opens, the Dispenser does not work.
using the water dispenser
Place a glass underneath the water outlet and push gently against the water dispenser lever with your glass.
Make sure the glass is in line with the dispenser to prevent the water from splashing out.
If you have just installed the refrigerator or installed a new water filter,Flush 3 gallons through filter before use (flush
approximately 6 minutes). Make sure that water flows clearly again before drinking.
using the ice off Function
When selecting the Ice Off mode, remove all ice cubes from the bucket. If you are not
using the ice dispenser, the ice cubes may clump together. Pull the lock lever
forward to throw away ice cubes or remove clumped ice from the bucket.
Push the bucket back until you hear a click.
Caution
When you do not use the water dispenser for 2~3 days (especially during the summer), the dispensed water
may have a funny smell or taste. If this occurs, we recommend that you discard the first 1~2 glasses for better
tasting water.
Caution
• In case ice doesn’t come out, pull out the ice bucket and press test button
located on the right side of ice maker.
• Do not press the test button continuously when the tray is filled with ice or water
as illustration. Water may overflow or ice jamming may occur.
• Normal Use
To fill ice bucket to maximum capacity after installation, make sure to do the following steps.
1. Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
2. Waiting 24 hours will allow your ice maker to cool properly.
3. Dispense 4 to 6 ice cubes into the glass.
4. After 8 and 16 hours, dispense a full glass of ice at each time.
When you dump the ice from the ice bucket, you should press the
dispenser lever once with ‘ICE CUBED’ or ‘CRUSHED’ function
ON to get new ice faster after replacing the ice bucket in the refrigerator.
Whenever all ice is used at one time, the above step 3 and4 must be
repeated (before dispense the first 4 to 6 ice cubes, it needs waiting 8 hours).
This will replenish the ice cubes and ensure maximum ice production.
Caution