Samsung RF4287HAPN-XAA - Manual (Page 15)

operating _15
02 OPERA
TING
6. If you turned off the water supply, turn it back on.
For a replacement water fi lter, you can visit
your local home Improvement center or
contact the Samsung Parts distributor.
Be sure the replacement water fi lter has the
SAMSUNG logo on the box and on the water
fi lter.
Link : http://www.samsungparts.com
Removing any residual matter inside the
water supply line after installing the water
fi lter.
1. Turn ON the main water supply and supply water
from water supply line.
2. Run water through the dispenser until the water
runs clear (approx. 6 to 7 minutes). This will clean
the water supply system and remove air from the
lines.
3. Additional fl ushing may be
required in some households.
4. Open the Refrigerator door and
make sure there are no water
leaks coming from the water
fi lter.
Be sure to fl ush the dispenser thoroughly,
otherwise water may drip from the dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to be a
minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is
less than 40 to 60 psi (276 to 414 kPa):
•
Check to see whether the sediment fi lter in the
reverse osmosis system is blocked. Replace the
fi lter if necessary.
• Allow the storage tank on the reverse osmosis
system to refi ll after heavy usage.
• If your refrigerator has a water fi lter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water fi lter.
If you have questions about your water pressure, call a
licensed, qualifi ed plumber.
CONTROLLING THE TEMPERATURE
Basic temperature of Freezer and
Refrigerator Compartments
The basic temperature and/or recommended
temperatures of the Freezer and Refrigerator
Compartments are -2°F and 38°F respectively.
If the temperature of Freezer and Refrigerator
Compartments are too high or low, adjust the
temperature manually.
Controlling the Freezer temperature
The Freezer temperature can be set between -8°F and
8°F to suit your particular needs. Press the Freezer
button repeatedly until the desired temperature is
shown in the temperature display. The temperature
will move 2°F degrees with each press (-2°F → -4°F
→ -6°F → -8°F → 8°F → 6°F → 4°F → 2°F → 0°F →
-2°F). Keep in mind that foods like ice cream may melt
at 4°F. The temperature display will move sequentially
from -8°F to 8°F.
Controlling the fridge temperature
The fridge temperature can be set between 46°F and
34°F to suit your particular needs. Press the Fridge
button repeatedly until the desired temperature is
shown in the temperature display. The temperature
will move 2°F degrees with each press (38°F → 36°F
→ 34°F → 46°F → 44°F → 42°F → 40°F → 38°F). The
temperature control process for the Fridge works just
like the Freezer process. Press the Fridge button to
set your desired temperature. After a few seconds,
the Fridge will begin adjusting towards the newly set
temperature. This will be refl ected in the digital display.
Recommend Temp (Freezer) : -2F Recommend Temp (Freezer) : -2F
DA68-01922A.indb 15 DA68-01922A.indb 15 2013.3.4 1:33:10 PM 2013.3.4 1:33:10 PM