Connecting to a power source – Samsung EC-SL102BBP-US User Manual
Page 13
12
Connecting to a Power Source
Ê SLB-10A rechargeable battery Specifi cation
Model
SLB-10A
Type Lithium
lon
Capacity 1050mAh
Voltage 3.7V
Charging time
Approximately 180 Minutes
You should use the rechargeable battery SLB-10A supplied with the
camera. Be sure to charge the battery before using the camera.
Ê Number of images and battery life: Using the SLB-10A
Battery life /
Number of images
Conditions
Still image
Approx. 140 MIN /
Approx. 280 shots
Using the fully charged battery, Auto
mode, 10M image size, Fine image
quality, Shot to shot interval: 30Sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the fl ash on every second shot.
Using the camera for 5 minutes and
then powering it off for 1 minute.
Movie
Approx. 120 MIN
Using the fully charged battery
640x480 image size
30fps frame rate
Ä These fi gures are measured under Samsung’s standard conditions
and shooting conditions and may vary depending on the user’s
methods.
Important information about battery usage.
å When camera is not in use, turn off the power.
å Please remove the battery if the camera will not be used
for long periods. Batteries can lose power over time and are
prone to leaking if kept inside the camera.
å Low temperatures (below 0°C) can affect the performance
of the battery and you may experience reduced battery life.
å Batteries will usually recover at normal temperatures.
å During extended use of the camera, the camera body may
become warm. This is perfectly normal.
Ê If you connect the AC adapter to the USB cable, you can use it
as an AC cable and recharge the spare battery with it.
- Using an AC cable
: Connect the AC adapter to the
USB cable. It can be used as a
power cable.
- Using a USB cable
: Remove the AC adapter.You can
download stored images to your
PC (p.86) or supply the power
to your camera through the USB
cable.