Samsung RSG257AAWP-XAA - Manual (Page 17)

setting up _17
4. Remove the filter cap and insert the filter
into the filter housing.
5. Slowly turn the water filter 90º clockwise
to align with the printing mark on the
cover, locking the filter in position. Make
sure to align the water filter label mark
with center of cover filter printing as
illustrated. Remember, do not over-
tighten.
Removing any residual matter inside the water
supply line after installing filter.
1. Turn ON the main water supply.
2. Press the Water button and push the dispenser pad.
3. Run water through the dispenser until the water runs clear (approx.
3L). This will clean the water supply system and remove air from the
lines.
4. Additional flushing may be required in some households.
5. Open the refrigerator door and make sure there are no water leaks
coming from the water filter.
A newly installed water filter cartridge may cause water to briefly
spurt from the water dispenser. This is due to air getting into the
line. It should pose no problem to operation.
01
SETTING UP
Cover filter
Align the indication
mark with lock position
Separation
of red cap
4 5
Water Ice
DA99-01746A (EN)-19.indd 17 14. 1. 18. �� 11:42