AT&T 915 - Manual (Page 9)

2. Set the tone/pulse switch. If you have touch tone
service, set the switch to TT (tone). If you have dial
pulse (rotary) service, set the switch to DP (pulse).
3. Connect the short line cord to the telephone.
Plug the line cord into the jack labeled TELEPHONE
LINE and thread the cord through the tabs under the
phone as shown.
4. Reverse the handset tab.
This tab holds the handset when you hang up. Hold
down the switchhook, and slide the tab up and out of its
slot. Turn the tab so that the end with the hook is up.
Then hold down the switchhook while you insert the tab
back into its slot.
6
Switchhook
Handset tab
Tone/pulse
switch
Telephone line cord
Modular
telephone
wall jack
Installation Installation