Installation – AT&T 915 User Manual

Page 10

5. Connect the handset to the telephone.

Plug the coiled cord into the handset jack on the left side
of the base unit. Plug the other end of the coiled cord
into the handset, then hang up.

6. Connect the line cord to a modular wall jack and

mount the phone on the wall jack as shown.

Make sure the cord snaps firmly into place. Place the
phone on the wall jack mounting studs and pull down

until it is held securely.

7. Check for dial tone.

Lift the handset and listen for a dial tone. If you cannot

hear a dial tone, slide the

VOLUME switch to the right.

If you still do not hear a dial tone, see the

In case of

difficulty section beginning on page 15 of this user’s

manual.

Installation