Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 84)

Section 5. Programming
5-44
NEW ENTRIES
Press the VIEW key.
Press the NEW ENTRIES key.
If no “NEW ENTRIES” have been made, the
display will show “No New Entries View Active
Set”. If new parameters have been set, but the unit
hasn’t been RESTARTed, the display will show
“NEW ENTRIES ‘ENTER’ to list”. Press the
ENTER key. The display will show the START
DELAY programming. Continuously pressing the
ENTER key will display all of the program
selections, SUBSTITUTING new parameters where
they’ve been changed, and return to the original
display.
Sequence: VIEW, NEW ENTRIES, ENTER(S)
5.7.2 Viewing Generated Information
The following sequence of entries are made on the Touchpad to examine the
sample information collected or generated by the controller and stored in its
memory.
SAMPLES TAKEN
Press the VIEW key.
Press the SAMPLES TAKEN key.
The display will show a count of all samples taken
during the current program. To make these changes
active, press the RESTART key, then again press it
to confirm your choice. The controller will then
wait until the designated time before starting its
sampling program.
REMAINING PULSES
Press the VIEW key.
Press the REMAINING PULSES key.
The display will show a countdown of incoming
pulses, decreasing from the programmed value.
Only available when either START DELAY or
SAMPLE INITIATION are using their Pulse Input
options or pulses generated by the 4-20mA input
option. The information is updated continuously
and can be left on the display as a progress
indicator.
Sequence: VIEW, REMAINING PULSES.