Campbell Scientific PST3/PST8 Pump and Slug Test System - Manual (Page 18)

PST3 *6 Location
1 . . . . . . . . . .Level well #1
2 . . . . . . . . . .Level well #2
3 . . . . . . . . . .Level well #3
4 . . . . . . . . . .Location ID #
5 . . . . . . . . . .Number of wells
6 . . . . . . . . . .Battery voltage
35 . . . . . . . . .Elapsed time
PST8 *6 Location
1 . . . . . . . . . .Level well #1
2 . . . . . . . . . .Level well #2
3 . . . . . . . . . .Level well #3
4 . . . . . . . . . .Level well #4
5 . . . . . . . . . .Level well #5
6 . . . . . . . . . .Level well #6
7 . . . . . . . . . .Level well #7
8 . . . . . . . . . .Level well #8
9 . . . . . . . . . .Location ID #
10 . . . . . . . . .Number of wells
11 . . . . . . . . .Battery voltage
35 . . . . . . . . .Elapsed time
Run PST. Select Option A.
NOTE: The 0.0 datum option does not require an offset.
(Manual reading) - (PST reading) = offset
See the *4 table, above.
Or using a laptop
The Offset
calculate the
offset
Enter the
offset(s) in the
*4 table
SECTION 3. TEST PROCEDURE
3-6
NOTE: These values
are updated only if the
SCAN or RECORDING
switch is on.
NOTE: These values
are updated only if the
SCAN or RECORDING
switch is on.