Campbell Scientific CM106 Tripod - Manual (Page 21)

CM106 Tripod
Remove the washers, nuts, and U-bolt from the U-bolt bracket. Install the
bracket as shown in FIGURE 5-12 (top). Tighten the nuts on the U-bolt until
the lock washers are compressed.
Route the 14 AWG wire from the ground lug on the bottom side of the
enclosure to the ground lug on the base of the tripod (FIGURE 5-8). Strip 1/2
in. of insulation from each end of the wire. Insert wire ends into the ground
lugs and tighten.
FIGURE 5-12. Enclosure with the –LM bracket
U-Bolt Bracket
Screw Head
Enclosure Tab
15