Samlex America S1500 - Manual (Page 23)

8. Appendix B
8-1. Operations of RS232 Serial Port
8-1-1. Hardware design：
This unit uses a 9-pin D connector and three of RS232 signal lines：
RECEIVE DATA (RXD)：PIN2
TRANSMIT DATA (TXD)： PIN3
DATA TERMINAL READY (DTR)：PIN4
8-1-2. The connection between this unit and a computer is as follows：
Computer Power Inverter
RXD RXD
TXD TXD
DSR DTR
RTS
CTS
GND GND
8-1-3. The RS232 interface of this unit employs ASCll code to implement the
asynchronous serial transmission control.
The byte structure is START BIP – 8 BIT DATA-STOP BIT Baud
rate：1200,2400,4800,(SET BY DIP-SW).
Parity check ：NONE, not settable
Data bit：8, not settable.
Stop bit：1, not settable.
20