LBL Lighting Fusion Jack 1.5" Low Profile Canopy - Manual (Page 2)

2
Using a split bolt connector, connect the low voltage hot
wire coming from the remote transformer to each hot wire
going to the ports.
Connect the low voltage common wire coming from the
remote transformer to each common wire going to the
ports.
Make sure that the split bolt connectors are properly
insulated.
1-9/16"
CEILING OR WALL
Install the Single Port Alone
Use a 1-9/16" hole saw to cut out the ceiling or wall where
the ports are going to be installed.
Bring the power out of the opening.
Unscrew the #6-32 screws to remove the back ring.
Screw the back ring (from the face with two holes) to the
power feed connector.
Unscrew the cap from the port.
POWER FEED
CONNECTOR
#6-32 SCREW
BACK RING
CAP
Cut the port wires so that 1-1/2" of it is exposed.
Strip the port wires and connect them to the low voltage
wires with the provided yellow wire nuts.
YELLOW
WIRE NUT
LOW VOLTAGE
WIRE
PORT WIRE
1B 2B
1
2
2
1
2
3
4
5
6
7
1
2
2A
2C
1
5
2
4
3