LBL Lighting MO Surf Elec Xfmr 300w 120v/12v - Manual (Page 2)

2
CROSSBAR
Remove the two transformer housing screws with the
provided Allen wrench to remove the crossbar.
#8-32
SCREW
CROSSBAR
Mount the crossbar to the electrical box with the provided
two #8-32 screws.
Install the Mounting Plate
1A
1
1 1
1B
2
2
2
Loosen and unscrew the center nut inside the transformer
housing, then remove the center nut and washer.
Gently pull out the plate and the transformer to expose the
power feed wire connections.
Remove the wire nuts to disconnect the power feed wires
from the transformer output wires.
Loosen the set screws on the strain relief and pull out
the power feed wires.
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the strain reliefs
leaving at least 6” of cord in the back of the transformer
housing for wire connections and tighten the set screws.
Strip 1/2" off the wire ends and reconnect the power
feed wires to their original connections.
Reinstall all the parts, taking caution of the wires and
wire connections, onto the nipple by reversing step 1.
2A
1
Adjust the Height
2
3
4
5
6
7
8
STRAIN RELIEF
POWER FEED WIRES
TRANSFORMER
HOUSING
SET SCREW
NUT
WASHER
PLATE
TRANSFORMER
9
NIPPLE
1
2
3
3
4
ALLEN
WRENCH
TRANSFORMER HOUSING
SCREW