LBL Lighting MO Flush Elec Xfmr 60w 277v/12v LED User Manual
Important safety information, Install the crossbar

Installation Instructions for
700MOPCEN_
1
1.3
GENERAL PRODUCT INFORMATION:
This product is ETL listed only when all the products used are
supplied by LBL Lighting, is suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product may be dimmed only with a low voltage electronic
dimmer. Using a dimmer not designed for low voltage electronic
applications may cause undesirable noise and potentially shorten
the life of the transformer.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
This product is intended for use with LBL low voltage lighting
systems only.
Read all instructions thoroughly before beginning installation.
Important Safety Information
To reduce the risk of fire and burns, do not install this lighting
system where the uninsulated open bus bar conductors can be
shorted or contact any conductive materials.
To reduce the risk of the system overheating and possibly causing a
fire, make sure all the connections are tight.
Do not install fixture assemblies closer than 6 inches to curtains or
similarly combustible materials.
Turn the electrical power off before modifying the lighting system in
any way.
The fixtures used with the system must be identified to be used
with the corresponding system.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
Load the circuit of the surface mount transformer to no more than
the maximum rated capacity as specified.
Monorail
60 Watt Electronic Flexible Power Feed Canopy Transformer
for LED Fixtures
TRANS-SFE60_
980MRLSFELEDFCT
1A
CAP WITH
NIPPLE
CROSSBAR
CANOPY
Disassemble the canopy by unscrewing the cap with
nipple until the crossbar has been separated.
1
Mount the crossbar to the electrical box with the
provided two #8-32 screws.
Pull the power wires out of electrical box for power
connection.
#8-32 SCREW
CROSSBAR
1B
3
2
1
Install the Crossbar