1a 1c, 1a 2a – LBL Lighting MO 4" Round Flexible End Feed Canopy User Manual
Page 2
2
CAP WITH NIPPLE
Slide the canopy up and secure it to the electrical box by
screwing the cap with nipple to the crossbar.
PLASTIC SCREW
ALLEN
WRENCH
Push the excess power feed wires into the canopy and tighten
the plastic screw with the provided Allen wrench.
Continue to Section 3 to connect to the Monorail.
Installation Option 2:
Connect Directly to Transformer
without Canopy
COM X1
X2 X3
X4
POWER
FEED
WIRES
Cut the end power feed wires to the desired length.
Feed the end power feed wires into the transformer.
With a sharp knife, cut 1" from the end of the wire web and
separate the wires 6" from each other.
Strip 1/2" off the wire ends.
Connect one end power feed wire to the "COM" terminal.
Temporarily connect the other wire to the terminal marked
"X2" (default).After installing the system completely, refer to
the remote transformer instructions for reconnecting this wire
to the proper terminal "X1- X4".
Continue to Section 3 to connect to the Monorail.
NOTE:
The provided power feed canopy is not used
in this procedure.
1A
1C
8
8
1D
9
10
9
1
2
3
4
5
6
7
1A
2A
5
6