LBL Lighting MO 4" Round Direct Feed Canopy Single-Feed - Manual

#8-32 ROUND
HEAD SCREW
REMOTE POWER
FEED CANOPY
WALL
1
Installation Instructions for
Remote Power Feed Canopy 1.2 REMOTECNPDIRW-_
980FWMPC1C
Wall Monorail
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeter).
Install the Remote Power Feed
Canopy
Connect each remote power feed canopy wire to one low
voltage wire (coming from the remote transformer into the
electrical box) with a wire nut.
Place all wires and wire nut connections inside the electrical
box.
Mount the remote power feed canopy to the electrical box
with the two #8-32 screws provided.
NOTE: Use the provided universal round crossbar when
the canopy holes do not line up with the electrical box
holes.
NOTE: The remote transformer should be installed prior
to these steps. Refer to the instructions provided with the
remote transformer.
Connect the Monorail to Remote
Power Feed Canopy
The Wall Monorail Direct Feed Standoffs and the remote
power feed canopy should be inline so that the Monorail runs
through the center point of the plastic disk.
Connect the Monorail to the standoffs (refer to the
instructions provided with the standoffs).
MONORAIL
STANDOFF
POWER FEED
CONNECTOR
REMOTE POWER
FEED CANOPY
PLASTIC DISK STANDOFF
LOW
VOLTAGE
WIRES
1A
1
2
3
2A
1
2
2
3
2
3
1
1
1 2