Connect the monorail, Install the power feed canopy, 1a 2a – LBL Lighting LED Illum MO Flush Elec Xfmr 60w 277v/12v LED User Manual
Page 3: 1a 3a
3
Connect the MonoRail
Remove the power feed cap from the power feed housing.
Completely back out the screw on the power feed cap.
NOTE:
The standoffs should be installed to support the
Monorail while connecting Monorail to the power feed
canopy. Refer to the instruction provided with the standoffs.
SCREW
POWER
FEED CAP
POWER FEED
HOUSING
Install the Power Feed Canopy
#8-32 SCREW
NOTE:
Use the provided universal round crossbar when the
canopy holes do not line up with the electrical box holes.
POWER LINE WIRES
Disconnect power to the electrical box.
Connect the white transformer wire to the neutral power line
wire with a wire nut.
Connect the black transformer wire to the hot power line
wire with a wire nut.
Connect a suitable ground in accordance with local electrical
codes.
Connect the canopy wires to the transformer output wires
with wire nuts.
Place the transformer, wires, and wire nut connections inside
the electrical box.
Mount power feed canopy to the electrical box with the two
#8-32 screws.
TRANSFORMER
1A
2A
3
2
5
7
7
5
1
2
3
4
6
5
7
1
2
1A
3A
2
1