LBL Lighting LED Illum MO 2.75" Direct Feed Canopy - Manual

Installation Instructions for
2” Single-Post Direct Power Feed Canopy
980MRL2RDSPFC-LED
1
1.1 REMOTECNPDIR2_-LED
Install the Power Feed Canopy
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
2" ELECTRICAL BOX
CEILING
WIRE NUT
SIDE
SCREWS
MOUNTING
PLATE
2
NOTE: The 2" electrical box should be installed prior to
these steps. Refer to the instruction provided with the 2"
electrical box.
Connect the two remote transformer wires to the canopy
power feed wires with wire nuts.
Remove the two side screws on the canopy with an Allen
wrench.
Attach the mounting plate to the 2” electrical box with two
#8-32 screws and reattach the canopy to the mounting plate
with the side screws.
Connect the LED-Illuminated
Monorail to the Power Feed Canopy
Remove the power feed cap from the power feed housing.
Completely back out the screw on the power feed cap.
NOTE: The standoffs should be installed to support the
Monorail while connecting Monorail to the power feed
canopy. Refer to the instruction provided with the standoffs.
SCREW
POWER
FEED CAP
POWER FEED
HOUSING
2
LED-Illuminated Monorail
1
2
3
1A 1A 1A 2A
1
2
3
2
1
2
1