LBL Lighting 2-Circuit MO X Conductive Connectors - Manual

Installation Instructions for
"X" Conductive Connectors 1.0 XCONNECTOR_-M-2
980MR2XCN
1
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product must be used with LBL 2- Circuit Monorail system
only.
The "X" conductive connectors connect four sections of the
Monorail end to end.
Install the "X" Conductive Connectors
Tighten all twelve M3 set screws with the provided 1.5 MM
Allen wrench. Make sure all set screw connections are tight for
a proper power connection and to avoid heat build up.
Push the four 2-Circuit Monorail sections completely onto the
"X" conductive connectors.
SECTION OF
THE 2-CIRCUIT
MONORAIL
"X" CONDUCTIVE
CONNECTOR
1.5 MM ALLEN
WRENCH
M3 SET SCREW
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
A Generation Brands Company
2-Circuit Monorail
1B 1A
1 2
1B 1A
1
1 1
1
2
2
2
2