LBL Lighting 2-Circuit MO Rail - Manual

Installation Instructions for
Straight 2-Circuit Monorail
980MR2RAIL
G P I : ENERAL RODUCT NFORMATION
Standard 2-Circuit Monorail bends horizontally to a radius as small
as 12". It cannot be bent vertically in the field.
1
2-Circuit Monorail
Determine the radius of the curve or circle.
On a piece of plywood draw the curved pattern.
Cut out the curved pattern from the plywood.
Make sure that cut out plywood is secured in place.
Hold on edge of the 2-Circuit Monorail against the plywood.
Bend the 2-Circuit Monorail
CIRCULAR
PLYWOOD
2-CIRCUIT
MONORAIL
CIRCULAR
PLYWOOD
Start bending the rest of the 2-Circuit Monorail against the
circular plywood until the desired curve or circle is achieved.
NOTE: Avoid straightening the bent 2-Circuit Monorail
which may cause the rails to separate from the insulator.
2-CIRCUIT
MONORAIL
1.1 RAIL-ST_-2
1A
1
2
3
4
5
6
1B