Connect the 2-circuit monorail to the transformer, 1a 2a 1a 2b, 1a 2c – LBL Lighting 2-Circuit MO Surf Elec Xfmr 300w 120v/12v User Manual
Page 3
POWER FEED CAP
KNURELD CAP
SCREW
3
SCREW
POWER FEED CAP
KNURLED CAP
CENTER WIRE
POWER FEED HOUSING
MIDDLE
CONTACT
Remove the power feed cap from the power feed housing.
Completely back out the screw on the power feed cap.
Loosen
the knurled cap on the power
(Do Not Remove)
feed housing and pull the center wire slightly out so that the
middle contact is not exposed in power feed housing.
NOTE:
The standoffs should be installed to support the
2-Circuit Monorail while connecting 2-Circuit Monorail to
the surface mount transformer. Refer to the instructions
provided with the standoffs.
Place a 2-Circuit Monorail section into the standoffs and
power feed housings.
Screw the power feed cap completely to the power feed
housing. Make sure that the power feed cap is not cross
threaded.
POWER FEED CAP
2-CIRCUIT MONORAIL
POWER FEED HOUSING
Tighten the screw on the power feed cap for proper power
connection.
Tighten the knurled cap for proper power connection.
Connect the 2-Circuit Monorail to
the Transformer
1A
2A
1A
2B
1
2
1
3
3
3
2
4
6
5
7
1A
2C
4
5
7
6