LBL Lighting 2-Circuit MO Adjustable Vertical Connector User Manual
Adjust the angle, Flexible vertical conductive connectors
1
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is suitable for dry locations only.
Installation Instructions for
Flexible Vertical Conductive Connectors
950MO2FXV
Adjust the Angle
Loosen the inner set screws on one connector with an
Allen wrench.
Pull the wires out of the connector.
The joining wires on the flexible connectors are pre-
cut for a 90-degree bend. For any angle other than
90 degrees, follow these instructions to adjust the
wires. Otherwise, skip ahead to section 2.
JOINING WIRES
SET SCREWS
SET SCREWS
STRIPPED
WIRES
Trim the wires to the proper length and strip off the last
3/8” of the insulation.
Insert the stripped wires into the connector.
Tighten the set screws with an Allen wrench to secure the
wires.
2-CIRCUIT MONORAIL
1.0
1.0
1.0
1A
1A
1A
2B
1
2
3
4
5
1
4
See also other documents in the category LBL Lighting Lighting:
- KENDALL (2 pages)
- LINNET PENDANT (1 page)
- MEZZO GP (4 pages)
- MEZZO GPCF (4 pages)
- MEZZO P (4 pages)
- MEZZO PCF (4 pages)
- MILO S (4 pages)
- MILO SCH (4 pages)
- RHUTHM S (2 pages)
- SOMEDAY GP (2 pages)
- SOMEDAY GPCF (2 pages)
- SOMEDAY P (2 pages)
- SOMEDAY CF (2 pages)
- Isla SP (1 page)
- Mason Classic (1 page)
- Mason SP (2 pages)
- Mason SPCF (2 pages)
- Aiko SP (1 page)
- Aiko SPCF (1 page)
- Olivia SP (1 page)
- Olivia SPCF (1 page)
- Zuri P (2 pages)
- Vera P (2 pages)
- Vera PCF (2 pages)
- Tindra P (4 pages)
- Akari P (1 page)
- Akari PCF (1 page)
- Isis GP (2 pages)
- Isis GPCF (2 pages)
- Rock Candy Cylinder SP (1 page)
- Rock Candy Cylinder SPCF (1 page)
- Miyu Classic SP (1 page)
- Miyu SP (2 pages)
- Miyu SPCF (2 pages)
- Sora SP (2 pages)
- Sora SPCF (2 pages)
- Julep S (2 pages)
- Julep SCF (2 pages)
- Pavia (2 pages)
- Rhythm PCF (2 pages)
- Rhythm P (2 pages)
- Juniper SF (4 pages)
- Juniper SFCF (4 pages)
- Alaya SP (4 pages)
- Icicle II SP (2 pages)