LBL Lighting MO Adjustable Cable Standoff - Manual

Installation Instructions for
Adjustable Angle Connectors 1.0 ACONNECTOR_-M-2
980MR2AAC
1
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product must be used with LBL 2-Circuit Monorail
system only.
These conductive connectors join two sections of the 2-Circuit
Monorail end to end at desired sharp horizontal angle.
Bend the three adjustable angle connectors so that the set
screws are exposed toward the outside of the bend.
Install the Adjustable Angle Connectors
Push the three 2-Circuit Monorail sections completely onto
the adjustable angle connectors.
Tighten all six M3 set screws with the 1.5MM Allen wrench.To
avoid heat build up and corrosion, make sure all set screw
connections are tight.
1.5 MM ALLEN
WRENCH
M3 SET SCREW
3
2-CIRCUIT
MONORAIL
ADJUSTABLE ANGLE CONNECTOR
SET SCREW
3
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
A Generation Brands Company
1B 1A
1
3
1C 1A
1
2
1B 1B
2
1
3
2
2
3
2-Circuit Monorail