LBL Lighting Modular New York Medium/Large T8 with Emergency Backup - Manual (Page 2)

2
Feed the switched, unswitched, and neutral/common power
line wires through the crossbar nipple.
Mount the crossbar assembly to the electrical box holes with
the two #8-32 screws provided.
Connect the crossbar to a suitable ground according to local
electrical codes.
CROSSBAR
ASSEMBLY
ELECTRICAL BOX HOLE
#8-32 SCREW
Place the housing on the crossbar nipple
Mark the location of the end holes in the housing onto the
wall and remove the housing.
NIPPLE
Install the anchors for the lag bolts at the points marked on
the wall.
Apply caulk around the anchor points and the electrical box.
ANCHOR
Mount the housing to the crossbar nipple with the nut and
lock washer provided.
Anchor the housing to the wall with lag bolts through the
metal and rubber washers provided.
Do not overtighten the lag bolts.
LAG BOLT
METAL WASHER
RUBBER WASHER
IMPORTANT: Make sure the test switch is at the
bottom when mounting the housing!
TEST SWITCH
1F
1D
1C
5
5
6
6
7
6
10
11
1E
8
9
11
12
13
9
8
9
13
12
13
11
10