LBL Lighting Dover W LED - Manual

Installation Instructions for
Dover Bath (LED)
980DOVERBWD
G P I : ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic dimmer.
This product may be mounted horizontally or vertically.
1
Wall
1.1 LW496_LED
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Connect the Power
Make sure the green ground screw head faces out of the
electrical box and ground the mounting plate in accordance
with local electrical codes.
Connect the white driver wire to the neutral power line wire
with a wire nut.
Connect the black driver wire to the hot power line wire with
a wire nut.
Properly place the driver and wire nut connections into the
electrical box.
2
3
1
DRIVER
1A
2
1
3
4
2B
GROUND
SCREW
INNER
THREADED HOLE
1
SHORT
SCREW
1
1
Install the Mounting Plate
Line up two inner threaded holes with the two electrical box
holes and screw in the short #8-32 screws (do not fully
tighten).
NOTE : These steps assume the threaded electrical box
holes are lined up horizontally. If the holes are lined up
vertically, follow the instructions opposite the desired
mounting direction.