LBL Lighting Dover W - Manual (Page 2)

2
Install the Backplate
Line up the two backplate slots with the two mounting plate
inner threaded holes.
Secure the backplate to the electrical box with the two long
#8-32 screws provided.
Install the Lamps and Shade
C AUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
Use Volt, Type T4, MAX 40 120 Watt
G9 Base Bi-Pin Halogen Lamp.
Push the lamp base completely into the socket. Repeat for all
five lamps.
LONG #8-32 SCREW
Connect the Power
Make sure that the mounting plate is grounded in accordance
with local electrical codes.
Connect the black fixture wire to the hot power line wire with
a wire nut.
Connect the white fixture wire to the neutral power line wire
with a wire nut.
Properly place all wires into the electrical box.
Remove the thumbscrew from the bracket on the backplate.
Place the shade onto the backplate.
Insert the thumbscrew through the hole in the shade and
screw it into the bracket on the backplate to secure the shade.
2A
3A
4A
4B
1
2
3
4
1
2
2
2
3
1
2
2
4
THUMB SCREW
SHADE
1
2
3
4
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2013 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!