LBL Lighting Athena W User Manual
Athena wall, Install the fixture, Installation instructions for

1
Installation Instructions for
Athena Wall
1.6
HW5498_2G60
980ATHENW
G
P
I
:
ENERAL
RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
Install the Fixture
MOUNTING
PLATE
Feed the fixture wires through the mounting plate center hole.
Connect the mounting plate to a suitable ground in accordance
with local electrical codes.
Connect the fixture white wire to the neutral power line wire
with a wire nut.
Connect the fixture black wire to the hot power line wire with
a wire nut.
Place all wires and wire nut connections properly inside the
electrical box.
Install the mounting plate to the electrical box with the
provided two #8-32 screws.
MOUNTING
PLATE
ELECTRICAL
BOX HOLE
#8-32 SCREW
CENTER HOLE
NOTE:
Use the provided crossbar assembly if the
mounting plate holes do not match with the electrical box
holes.
1A
1B
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Wall
1
2
3
4
5
6
1
3
4
6
6