LBL Lighting Tulip W - Manual (Page 2)

1C
MOUNTING PLATE
6
7
Place all wires and wire nut connections properly inside the
electrical box.
Slide the mounting plate center hole onto the exposed
threaded nipple. Secure the mounting plate in place by
tightening the cap to threaded nipple.
CAP
6
Use MAX 120 Volt, 75 Watt Type DC
Bayonet, BA15d Base Lamp.
Align the pins on the DC Bayonet lamp with the socket "L"
slots. Push the lamp completely into the socket and rotate it
clockwise to lock it in place.
8
NOTE: Use only your fingers and a soft cloth to install
the lamp.
1D
PIN
DC BAYONET
LAMP
SOCKET "L" SLOT
8
2
CROSSBAR
EXPOSED THREADED
NIPPLE
7
1F
10
GLASS
SHADE
Place the glass shade onto the mounting plate. Align the glass
shade holes with the mounting plate holes. Tighten the thumb
screws to secure the glass shade in place.
THUMB
SCREW
MOUNTING
BRACKET
MOUNTING
PLATE
10
1E
LAMP SHIELD
SOCKET HOUSING
9 Place the lamp shield onto the socket housing. Screw
(Do Not Tighten) the lamp shield onto the socket housing
just enough (a couple of threads) to secure it in place.
10
9
NOTE: Do not over tighten the thumb screws which may
cause the glass shade to break.