Install the lamp & shade, Save these instructions – LBL Lighting Aliseo Wall User Manual
Page 2
1C
Place all wires and wire nut connections properly inside the
electrical box.
Align the mounting plate holes with electrical box holes and
tighten with two #8-32 screws to secure the fixture in place.
6
ELECTRICAL
BOX HOLE
7
#8-32
SCREW
6
7
7
2
Install the Lamp & Shade
LAMP
2A
SOCKET
Screw the lamps into the sockets.
1
Use
MAX
40
Watt Type B10 E12 Base
Candelabra Lamp With Each Socket
1
1
Place the glass shade onto the mounting plate.
While supporting the glass shade in place replace the caps and
thumb screws on top and bottom of the shade. Make sure the
thumb screws are tight to secure the glass shade in place.
2
2B
GLASS
SHADE
3
2
3
THUMB SCREW
3
END CAP
SAVE THESE INSTRUCTIONS!
NOTE:
Do not over tighten the thumb screws which may
cause the glass shade to break.
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company