LBL Lighting Dimensions Chandelier - Manual

Installation Instructions for
Dimensions Chandelier Head 1.3 HA337_1A35MRL
980MRLDMNSCH
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product is intended to be used with LBL Monorail system.
1
Install the Lamp and Disk
CURVED
SECTION
CRYSTAL
GLASS DISK
ACCESSORY
SPRINGS
CURVED
SECTION
NOTE: The Crystal disk must be removed when relamping.
With the small hole section of the crystal glass disk facing
towards lamp, place edge of the crystal glass disk into curved
section of accessory springs.
CAUTION: Do not install the crystal glass disk with the
large hole section of it facing towards the lamp, which will
cause the crystal glass disk eventually to fall out.
LAMP
SOCKET
Align and push the lamp pins completely into the socket holes.
Use MAX 35 Watt MR11 Front Cover Halogen
Lamp .
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
Monorail
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1A 1A
1
1
2
2
2
2
1A 1B
2