LBL Lighting Round MO Chandelier with Transformer - Manual (Page 3)

3
3 Slide each stem into one of the power posts on the dome
cover.
Tighten both set screws in the power posts to secure the rods.
These set screws must be . very tight
4
2C
1
1 For 120” stems: Slide the separator down the rods until it
rests on the joining posts.
2A
SEPARATOR
JOINING POST
ROD
1
2 For 120” stems:
very tight.
Attach additional rods to the joining posts.
Insert each rod into a joining post and tighten the set screws
on the post.These set screws must be
2B
JOINING POST
ROD
SEPARATOR
SET SCREW
2
Push the Monorail hub completely onto the end of the stems.
Tighten the set screws on either side of the hub.These set
screws must be very tight.
3A
STEM
MONORAIL HUB SET SCREW
SET SCREW
(BEHIND)
ROD
SET SCREW
3 Slip each cable grip under the Monorail.Tighten the set screw
to hold it in place.
Feed each aircraft cable through a cable grip.
Once all cables are through a cable grip, pull on the excess
cable at each cable grip to put even, gentle tension on all the
cables.
Cut off any excess cable.
Refer to the instructions provided with the chandelier heads
to attach the heads to the Monorail.
3B
1
MONORAIL
SET SCREW
EXCESS CABLE
Attach the Stem
4
5
6
2
CABLE GRIP
AIRCRAFT CABLE
7
Attach the Monorail Circle
3
4
1
2
1