LBL Lighting Straight Monorail User Manual
Straight monorail

Installation Instructions for
Straight Monorail
1.1
RAIL-ST-_
980MRLRAIL
G
P
I
:
ENERAL
RODUCT NFORMATION
Standard Monorail bends horizontally to a radius as small as 6" and
vertically to a radius as small as 24".
FRONT VIEW OF
THE MONORAIL
VERTICAL BENDING
HORIZONTAL BENDING
TOP VIEW OF
THE MONORAIL
NOTE:
There are three techniques for bending the
Monorail horizontally, Plywood Template,Wiremold Pipe
Bender, and Freestyle.When bending the Monorail
vertically, only use the Wiremold Pipe Bender technique.
Monorail bends horizontally easier than vertically.When
bending the Monorail vertically, do small bends at a time
and avoid bending the Monorail back which may cause the
rails to separate from the insulator.
Bending the Monorail
Plywood Template to Form a Curve
or Circle (Horizontal Bend Only)
1
Determine the radius of the curve or circle.
On a piece of plywood draw the curved pattern.
Cut out the curved pattern from the plywood.
Make sure the cutout plywood is secured in place.
Hold one edge of the Monorail against the plywood.
MONORAIL
CIRCULAR
PLYWOOD
1B
1A
1
2
3
4
2A
1A
5
Monorail