LBL Lighting Debuzzing Dimming Coil User Manual
Debuzzing dimming coil, Installation instructions for, General product information

Installation Instructions for
Debuzzing Dimming Coil
1
GENERAL PRODUCT INFORMATION:
This product is suitable for dry locations only.
This product must only be used with Encompass Lighting low-
voltage systems.
ACCESSORIES
Install the Dimming Coil in Surface
150 Watt Transformers
Turn the power to the electrical box off.
On side of the transformer canopy, remove the #4-40
Phillips head screws and lift the dome cover off.
Loosen the inside nut and remove the crossbar with the
attached nipple.
Connect one dimming coil wire to the 120 volt hot power
line wire with a wire nut.
Connect the other dimming coil wire to the black
extension wire with a wire nut.
Connect the 120 volt neutral power line wire to the white
extension wire with a wire nut.
Feed the extension wires through the nipple attached to
the crossbar and mount the crossbar to the electrical
box with the two #8-32 screws.
Slip the transformer housing onto the nipple and secure
it with the inside nut.
Connect the black and white extension wire to the black
and white 120 volt transformer wires respectively with
wire nuts.
Refer to the instructions provided with the surface mount
transformers to complete the installation.
DIMMING COIL
120 VOLT NEUTRAL
POWER LINE WIRE
120 VOLT HOT
POWER LINE WIRE
CROSSBAR
#8-32 SCREW
NIPPLE
TRANSFORMER
HOUSING
DOME COVER
INSIDE
NUT
950DIMCOIL
1.0
_00DIM_
1A
1
2
3
4
5
6
7
8
9
10
2
3
4
5
6
7
8
9