LBL Lighting Apex Swivel - Manual

Installation Instructions for
Apex Swivel 1.4 HD162_1A50FSJ
980FSJAPXS
Install the Lamp
1
LAMP
SOCKET
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
Use Watt MR16 Front Cover MAX 50
Halogen Lamp.
G P I : ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
Colored and Dichroic lenses, or Diffuser, Linear Spread, and Soft
Focus Lenses, or Structure Louvers are the compatible accessories.
Loosen the thumb screws on the socket.
Slide the socket back.
THUMB
SCREWS
ACCESSORY LENS
Push the MR16 lamp pins all the way into the socket.
Put the optional accessory lens into the ring.
Slide the socket forward so that the edge of the lamp sits
inside the ring.
Tighten the thumb screws on the socket.
WARNING: Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible
materials. Maintain at least 9" (Inches) of clearance directly in
front of the fixture.
AVERTISSEMENT: Risque du feu. Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du
mur, des rideaux et des matériaux combustibles. Maintenez au
moins 9" (Pouces), 230 mm, de dégagement directement
devant le montage.
1A
1
Fusion Jack
™
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
2
3
4
5
6
2
1
3 6
4
5