LBL Lighting Tear-SI Coax P User Manual
Tear-si coax, Fusion jack, Installation instructions for

GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
Fusion Jack™
1
Installation Instructions for
Tear-SI Coax
1.3
HS241_
980FSJTRSICP
Feed the fixture coaxial cable through the inner and outer glass
shades. Slide the glass shades down the cord and rest them
onto the socket assembly.
Cut the coaxial cable to the desired length.
1
SET SCREW
Back out (do not remove) the set screw on tip of the
connector with the provided Allen wrench.
ALLEN WRENCH
3
Back out (do not remove) the set screw on the conical
connector with the provided Allen wrench.
SET SCREW
ALLEN WRENCH
4
1B
1C
4
3
2
CONNECTOR
1A
OUTER GLASS SHADE
SOCKET ASSEMBLY
FIXTURE COAXIAL
CABLE
INNER GLASS SHADE
3