Adjust the fixture height (optional), Assemble the fixture – LBL Lighting Veneto Venti SPCF User Manual

Page 2

STEM ASSEMBLY

Adjust the Fixture Height (Optional)

NOTE:

Install a stem extension or a combination of the

stem extensions (above the cable hub) to create the
desired length.The extension stems are not field
cuttable.

NOTE: If height extention stems are not being added,
skip this step.

NOTE: If height extension stems have been added,
skip this step.

Assemble the Fixture

Feed the fixture wires from the socket assembly through the

stem assembly and tighten it completely to the socket

assembly.

Leaving enough wire to make power connections, cut off the

excess wire and sleeve.

WIRE SLEEVE

FIXTURE WIRES

Temporarily remove the canopy and half ball pivot from the

assembly by unscrewing the pivot from the stem with the hub.

Feed the fixture wires and wire sleeve from the socket

assembly through the stem with the cable hub and tighten it

completely to the socket assembly.

Feed the fixture wires and wire sleeve from the through the

optional extension stem(s) and tighten it completely to the

stem with the hub.

Feed the fixture wires and wire sleeve through the canopy and

half ball pivot, then tighten completely to the new extension

stem.

Leaving enough wire to make power connections, cut off the

excess wire and wire sleeve.

EXTENSION STEM

CABLE HUB

HALF BALL PIVOT

CANOPY

STEM

SOCKET
ASSEMBLY

FIXTURE WIRES

WIRE SLEEVE