LBL Lighting Constellation Chandelier - Manual (Page 2)

Secure the backplate to the anchors with a screw and washer
on each of the four anchors.
2
Attach the Canopy
Line up an anchor tip with one of the marks on the ceiling, and
push the anchor into the ceiling up to the threads.
Screw the anchor in the rest of the way with a screwdriver.
Repeat steps 6-7 for the other three anchors.
ANCHOR
ANCHOR HOLE
ANCHOR
Hook a safety cable through the safety brackets on each end of
the canopy and backplate.
Connect the green canopy wire and bare copper backplate
wire to a suitable ground according to local electrical codes.
Connect the black canopy wire to the hot power line wire
with a wire nut.
Connect the white canopy wire to the neutral power line wire
with a wire nut.
SAFETY
CABLE
Place all wires and safety cables inside the canopy.
Slide the canopy onto the backplate.
Replace and tighten the six #8-32 screws to secure the canopy.
CANOPY
SCREWS
SAFETY
BRACKET
SAFETY
BRACKET
ANCHOR SCREW
WASHER
1E
8
1D
5
6
7
8
8
8 8
2A
1
2B
2
3
4
5
6
7
2C
1
1
3
4
2
6
6
6
5