Install the lamps, shade, and diffuser – LBL Lighting Vera SCF User Manual

Page 3

#8-32
SCREW

CROSSBAR

Place all wires and wire nut connections properly inside
the electrical box.

Secure the mounting plate to the electrical box with the
two provided #8-32 screws.

Loosen the set screw on the primary strain relief.

Align the canopy center hole with the mounting plate
center hole.

Slide the canopy up against the ceiling and secure it in
place by screwing in and tightening the primary strain

relief into the crossbar.

Do not turn the cord.

Push the cord into the canopy and line up the marked
point on the cord with bottom of the primary strain
relief.

Tighten the plastic set screw to secure the cord.

STRAIN RELIEF

NOTE:

It is recommended that one person hold the

fixture while the electrician finishes the installation.

CORD

SET SCREW

CAUTION: To reduce the risk of a burn or electric
shock during re-lamping, disconnect the power to
the fixture.

Install the Lamps, Shade, and Diffuser

SOCKET

LAMP

Use

GX24Q-3 Base

MAX 32 Watt

Triple Tube Compact Fluorescent Lamp.

Push the lamp base into the socket.

NOTE: To re-lamp, reach in the fixture from the
opening above.