LBL Lighting MEZZO GPCF - Manual (Page 4)

4
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
Install the Lamp and Diffuser
5A
2
Place all wires, wire nut connections, and the secondary
strain relief properly inside the canopy.
Align the canopy holes with the mounting plate holes
and secure the canopy in place
by reinstalling the three
screws on the canopy with the Allen wrench provided .
Adjust the aircraft cables until the fixture is level; feed
the cable into the cable clutch to raise the fixture and
push in on the cable clutch nipple to release the cable
and lower the fixture.
NOTE: It is recommended that one person hold the
fixture while the electrician finishes the installation.
4D
8
9
10
12
13
SCREW
ALLEN
WRENCH
SOCKET
ASSEMBLY
DIFFUSER
LAMP 1
2
3
Reach inside the inner shade and push the lamp base
into the socket.
Install the diffuser to the socket assembly by screwing it
in.
To re-lamp, reverse this section.
1
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
Use GX24Q-3 Base
MAX 32 Watt
Triple Tube Compact Fluorescent Lamp.
11
Reconnect the power cord wires to their original
connections (reversal of 3A).
Connect the mounting plate and the fixture ground
wire to a suitable ground in accordance with local
electrical codes.
Connect the white ballast wire to the neutral power line
wire.
Connect the black ballast wire to the hot power line
wire.
BALLAST
11
10
9
4C
8
9
8
CABLE
CLUTCH
14
13
14